RSX L4-2.0L (VTEC) (2002)
/Page-5500001.png)
Malfunction Indicator Lamp: Description and Operation
Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes)
The vehicle has certain "readiness codes" that are part of the on-board diagnostics for the emissions systems. If the vehicle's battery has been
disconnected or gone dead, if the DTCs have been cleared, or if the ECM/PCM has been reset, these codes are reset. In some states, part of the emissions
testing is to make sure these codes are complete. If all of them are not complete, the test cannot be finished.
To check if the readiness codes are complete, turn the ignition switch ON (II), but do not start the engine. The MIL will come on for 15 - 20 seconds. If
it then goes off, the readiness codes are complete. If it blinks several times, one or more readiness codes are not complete. To set each code, drive the
vehicle or run the engine as described in the procedures.
