acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Malfunction Indicator Lamp|Locations|Page 4552 > < Malfunction Indicator Lamp|Locations|Page 4550
Page 13
background image

70. Measure voltage between body ground and ECM/PCM connector terminal E5.

Is there about 5 V?

YES Replace the FTP sensor.

NO - Go to step 71.

71. Turn the ignition switch OFF.
72. Disconnect ECM/PCM connector E (31P).

73. Check for continuity between ECM/PCM connector terminal E5 and body ground.

Is there continuity?

YES - Repair short in the wire between the ECM/PCM (E5) and the FTP sensor.

NO - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the
symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.

74. Turn the ignition switch OFF.
75. Turn the ignition switch ON (II).

76. Measure voltage between ECM/PCM connector terminal E29 and body ground.

Is there about 5 V (or battery voltage)?

YES - Go to step 80.

Malfunction Indicator Lamp|Locations|Page 4552 > < Malfunction Indicator Lamp|Locations|Page 4550