RSX L4-2.0L (VTEC) (2002)
/Page-4533002.png)
7. Disconnect the seat belt tensioner connector (A). Remove the retractor mounting self-tapping ET screw (B) and the retractor bolt (C), then remove
the front seat belt (D) and retractor (E).
Upper / Lower Anchor Bolt Construction
8. Install the belt in the reverse order of removal, and note these items:
-
If the threads on the retractor mounting self-tapping ET screw are worn out, use an oversized self-tapping ET screw (P/N 90133-SZ4-0030)
made specifically for this application.
-
Check that the retractor locking mechanism functions.
-
Assemble the washers, collars, and bushing on the upper and lower anchor bolts as shown.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the front seat belt.
-
Make sure the seat belt tensioner connector is plugged in properly.
-
Reconnect the negative cable to the battery.
-
Enter the anti-theft code for the radio, then enter the customer's radio station presets.
