RSX L4-2.0L (VTEC) (2002)
55. Move the special tool back and forth several times to make the piston seal ring fit snugly in the piston.
56. Set the new bushing (A) on the special tool, and insert the special tools into the cylinder housing (B).
57. Set the cylinder in a press, and install the bushing (A) into the bottom of the cylinder by pressing on the tool with press. Do not push on the tool
with excessive force as it may damage the new bushing.
58. Coat the sliding surface of the special tool (A) and new cylinder end seal (B) with power steering fluid. Place the seal on the special tool with its
grooved side (C) facing opposite the special tool.
59. Apply a thin coat of grease to the inside of the special tool.