RSX L4-2.0L (VTEC) (2002)
/Page-3312002.png)
No.2
Standard or new
4.85 mm
Service limit
When worn or damaged
No.3
Standard or new
4.90 mm
Service limit
When worn or damaged
No.4
Standard or new
4.95 mm
Service limit
When worn or damaged
No.5
Standard or new
5.00 mm
Service limit
When worn or damaged
No.6
Standard or new
5.05 mm
Service limit
When worn or damaged
3rd gear collar length
Standard or new
43.9 - 44.0 mm
Length of 3rd gear collar flange from end
Standard or new
5.25 - 5.40 mm
Service limit
When worn or damaged
Sealing ring thickness
Standard or new
1.91 - 1.97 mm
Service limit
1.86 mm
Width of sealing ring groove
Standard or new
2.025 - 2.060 mm
Service limit
2.080 mm
Clutch feed pipe O.D.
3rd clutch feed pipe
Standard or new
11.47 - 11.48 mm
Service limit
11.45 mm
1st clutch feed pipe
Standard or new
6.97 - 6.98 mm
Service limit
6.95 mm
Clutch feed pipe bushing O.D.
3rd clutch feed pipe
Standard or new
11.500 - 11.518 mm
Service limit
11.530 mm
1st clutch feed pipe
Standard or new
7.018 - 7.030 mm
Service limit
7.045 mm
ATF guide of sealing rind contact I.D.
Standard or new
29.00 - 29.021 mm
Service limit
29.05 mm
Idler gear shaft
Diameter of needle bearing contact area
End cover side
Stanard or new
32.003 - 32.013 mm
Service limit
When worn or damaged
Thickness of cotters
Standard or new
1.39 - 1.42 mm
Reverse idler gear Reverse idler gear shaft diameter at needle bearing contact
Standard or new
14.99 - 15.00 mm
area
