SLX V6-3.2L SOHC (1996)
Coolant Temperature Sensor/Switch (For Computer): Description and Operation
ENGINE COOLANT TEMPERATURE (ECT) SENSOR
The engine coolant temperature (ECT) sensor is a thermistor (a resistor which changes value based on temperature) mounted in the engine coolant
stream. Low coolant temperature produces a high resistance of 100,000 ohms at -0°C (-40°F). High temperature causes a low resistance of 70
ohms at 130°C (266°F). The PCM supplies a 5-volt signal to the ECT sensor through resistors in the PCM and measures the voltage. The signal
voltage will be high when the engine is cold and low when the engine is hot. By measuring the voltage, the PCM calculates the engine coolant
temperature. Engine coolant temperature affects most of the systems that the PCM controls.
The scan tool displays engine coolant temperature in degrees. After engine start-up, the temperature should rise steadily to about 85°C (185°F). It
then stabilizes when the thermostat opens. If.the engine has not been run for several hours (overnight), the engine coolant temperature and intake
air temperature displays should be close to each other. A hard fault in the engine coolant sensor circuit will set DTC P0117 or DTC P0118. An
intermittent fault will set a DTC P0114 or P1115.
