SLX V6-3.2L SOHC (1996)
Oil Pan: Service and Repair
1. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
2. Disconnect battery ground cable from battery, then insulate cable end with electrical tape, or equivalent.
3. Remove oil dipstick from oil tube, then raise and support vehicle. Support rear of vehicle with safety stands.
4. Remove stone guard, then the radiator under fan shroud.
5. Remove suspension crossmembers.
6. Remove flywheel inspection cover.
7. Using Pitman Arm Removal Tool No. J-29107, or equivalent, remove pitman arm from steering gear.
8. Disconnect idler arm from frame member.
9. Support front axle housing with jack, then remove two bolts and nuts from isolators on both sides. Lower axle assembly from vehicle.
10. Remove oil pan retaining bolts, then using Seal Cutter tool No. J-37228, or equivalent, remove oil pan from engine block. Sealant is applied to
entire mating surface of oil pan. Do not pry on pan, damage to oil pan flange may result.
11. Reverse procedure to install, noting the following:
a. Completely remove all old sealant and oil from oil pan and sealing surface of engine block, then apply a 0.18 inch bead of sealant part No.
TB-1207C, or equivalent to sealing surface of oil pan. Oil pan must be installed within 30 minutes of sealant application.
12. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
