SLX V6-3.2L SOHC (1996)
Water Pump: Service and Repair
1. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
2. Disconnect battery ground cable, then insulate cable end with electrical tape.
3. Drain engine coolant from radiator.
4. Remove timing belt.
5. Remove idler pulley, then the water pump.
Fig. 69 Water Pump Tightening Sequence
6. Reverse procedure to install, noting the following:
a. Ensure all gasket material has been removed from engine block sealing surface.
b. Torque water pump retaining bolts in sequence shown, Fig. 69, to 13 ft. lbs.
c. Tighten idler pulley retaining bolt to specification.
7. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
