SLX V6-3.2L SOHC (1996)
Engine Control Module: Service and Repair
EEPROM Programming
EEPROM Programming
1. Set-up - Ensure that the following conditions have been met:
^
The battery is fully charged.
^
The ignition is "ON."
^
The Vehicle Interface Module cable connection at the DLC is secure.
2. Program the PCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user's instructions.
3. If the PCM fails to program, proceed as follows:
^
Ensure that all PCM connections are OK.
^
Check the Techline equipment for the latest software version.
^
Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. The replacement PCM must be
programmed.
Functional Check
1. Perform the On-Board Diagnostic System Check.
2. Start the engine and run for one minute.
3. Scan for DTCs using the scan tool.
