SLX V6-3.2L SOHC (1996)
7.
Momentarily push and release the START button on the Smart Cable to begin the PCM Update. While the PCM is updating for 1 to 3 minutes, the
yellow light on the Smart Cable flashes, and the green light glows steadily.
To avoid permanent PCM damage, do not disconnect the Smart Cable or turn the ignition switch to ACC (I) or Lock (0) while the yellow light is
flashing.
8.
When the yellow and green lights glow steadily, indicating that the update is complete, disconnect the Smart Cable from the DLC.
9.
Turn the ignition switch to Lock (0).
* 10. Reconnect the EHCU connector to the EHCU if needed. *
11.
Use the PGM Tester to clear any remaining DTCs
12.
Recheck the broadcast code with the PGM Tester. The code must match the update you just installed.
13.
If the vehicle still has the problem you tried to correct with the update, refer to the appropriate service manual or ETM for troubleshooting
information.
