SLX V6-3.2L SOHC (1996)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
ENGINE COOLANT TEMPERATURE (ECT)SENSOR
Removal Procedure
Notice: Care must be taken when handling the Engine Coolant Temperature (ECT) Sensor. Damage to the ECT sensor will affect proper
operation of the fuel injection system.
1. Disconnect the negative battery cable.
2. Drain the radiator coolant. Refer to Draining and Refilling Cooling System in Engine Cooling.
3. Remove the upper intake manifold assembly. Refer to Upper Intake Manifold.
4. Disconnect the electrical connector.
5. Remove the ECT sensor from the coolant crossover.
Installation Procedure
1. Apply sealer or the equivalent to the threads of the ECT sensor.
2. Install the ECT sensor in the coolant crossover.
Tighten:
Tighten the ECT sensor to 30 Nm (22 lb ft.).
3. Connect the electrical connector.
4. Install the upper intake manifold assembly. Refer to Upper Intake Manifold.
5. Fill the radiator with coolant. Refer to Draining and Refilling Cooling System in Engine Cooling.
6. Connect the negative battery cable.
