SLX V6-3.2L SOHC (1996)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
PCM - How to Update Programming
June 7, 1999
BULLENTIN NO.
99-019
YEAR
1996 and LATER
MODEL
SLX
Updating the SLX PCM
The procedures in this service bulletin will be used and referenced in other service bulletins.
PCMs (powertrain control modules) in 1996 and later SLXs are programmable. The tool used to reprogram (update) SLx PCMs is a portable
programming device called the Smart Cable.
When correctly programmed, the Smart Cable can read an SLX's current PCM broadcast code, decide if the code is correct and, if needed, update the
PCM with another code. You can reprogram the Smart Cable using your DCS workstation.
This bulletin describes:
-
How to Reprogram a Smart Cable
-
How to update a PCM with a programmed Smart Cable
-
How to Diagnose a Faulty Smart Cable
-
Who to call if you have problems with a Smart Cable
WARRANTY CLAIM INFORMATION
Refer to the bulletin for the symptom you are repairing.
Skill level: Repair Technician
REQUIRED TOOLS AND EQUIPMENT
Smart Cable kit: PIN PTS-BOO1
Includes cable, box, a copy of this bulletin (99-019), and a sheet on interpreting Smart Cable LED patterns.
-
PC Interface kit: P/N VET01002528
This is the same kit used to connect the PGM Tester to the DCS computer when you update the Tester's program card. It includes a cable and an
attached adapter.
-
110 VAC/12 VDC Power Supply:
P/N VET02002426
This is the same power supply used by the PGM Tester.