SLX V6-3.2L SOHC (1996)
6. Apply a setting mark across the steering wheel and shaft so parts can be reassembled in their original position.
7. Move the tires to the straight ahead position before removing the steering wheel and remove wheel with J-29752.
8. Feed wiring though the wheel and remove wheel.
9. Remove the steering lower cover and engine hood opening lever.
10. Remove the driver knee bolster assembly.
11. Remove the steering column cover.
12. Remove air conditioning lower duct.
13. Disconnect the 2-pin wiring harness connectors located at the base of steering column.
CAUTION: Never apply force to the steering wheel in the direction of the shaft by using a hammer or other impact tools in an attempt to remove
the steering wheel. The steering shaft is designed as an energy absorbing unit.
14. Remove the combination switch assembly with SRS coil.
NOTE: SRS coil is a part of combination switch assembly, which cannot be replaced separately. Therefore, be sure not to remove the SRS coil
from the combination switch assembly.
