SLX V6-3.2L SOHC (1996)
KNOCK SENSOR
Removal Procedure
1. Drain cooling system.
2. Remove the upper intake manifold.
3. Remove the lower intake manifold.
4. Remove the front bolt from the bracket that secures the upper coolant pipe.
5. Remove the bypass hose from the upper coolant pipe.
6. Remove the upper radiator hose.
7. Disconnect the electrical connector from the bracket.
8. Remove the rear bolt from the bracket that secures the upper coolant pipe.
9. Remove the coolant pipe.
10. Disconnect the electrical connector from the knock sensor.
11. Unscrew the knock sensor from the engine block.
Installation Procedure
Notice: Do not apply thread sealant to the sensor threads. The sensor is coated at the factory and applying additional sealant will affect the sensor's
ability to detect detonation.
1. Screw the knock sensor into the engine block.
Tighten:
Tighten the knock sensor to 7 Nm (62 lb in).
2. Connect the electrical connector to the knock sensor.
3. Install the upper coolant pipe.
^
Lubricate the O-ring seal on the end of the coolant pipe with fresh engine coolant.
4. Install the rear bolt that secures the upper coolant pipe.
Tighten:
