TL L5-2451cc 2.5L SOHC G25A4 FI (1995)
2. Install the camshaft seal with the open side (spring) facing in.
3. Apply liquid gasket to the head mating surfaces of the No. 1 and the No. 7 camshaft holders.
^
Apply liquid gasket to the shaded areas.
NOTE: Be sure to wipe any liquid gasket off the surface of the No. 7 camshaft holder where the distributor is to be attached.
4. Tighten each bolt two turns at a time in the sequence to ensure that the rockers do not bind on the valves.
^
Tighten the 8 mm bolts to 22 Nm (16 ft. lbs.) then apply engine oil.
^
Tighten the 6 mm bolts to 12 Nm (8.7 ft. lbs.) then apply engine oil.
^
The 6 mm bolts are 3, 6, 9, 12, 15
