TL L5-2451cc 2.5L SOHC G25A4 FI (1995)
7. Remove the wheel sensor wire bracket' then remove the wheel sensor from the knuckle.
NOTE: Do not disconnect the wheel sensor connector. Use ball joint removers to separate the ball joints from the suspension or tie-rod end.
CAUTION: Be careful not to damage the ball joint boot.
8. Clean any dirt or grease off the ball joint.
9. Remove the cotter pin from the tie-rod end ball joint castle nut, and remove the nut.
10. Apply grease to the special tool on the areas shown. This will ease installation of the tool and prevent damage to the pressure bolt threads.
11. Install a 12 mm hex nut on the ball joint. Be sure that the hex nut is flush with the ball joint pin end to prevent damage to the threaded end of the
ball joint.
12. Use the special tool as shown. Insert the jaws carefully, making sure you do not damage the ball joint boot.
13. Adjust the jaw spacing by turning the pressure bolt.
NOTE: If necessary, apply penetrating type lubricant to loosen the ball joint.
14. Once the tool is in place, turn the adjusting bolt as necessary to make the jaws parallel. Then hand-tighten the pressure bolt, and recheck the jaws
to make sure they are still parallel.
