TL L5-2451cc 2.5L SOHC G25A4 FI (1995)
6.
Install the new knock sensor, tighten it to 34 N.m (3.4 kg-m, 25 lb-ft). Reconnect the electrical connector. If necessary, make up the tool shown
below to use as an aid in threading the sensor into the hole.
7.
Reinstall the wiring harness mounting bolt and the breather hose.
8.
Reconnect the battery negative terminal.
9.
Enter the radio anti-theft code and the customer's station presets. Reset the clock.
Rear Knock Sensor Replacement
1.
Get the customer's anti-theft radio code. Write down the radio station presets.
2.
Disconnect the battery negative terminal.
3.
Locate the intake air bypass control solenoid underneath the rear of the intake manifold. Pull the solenoid and its vacuum tank loose from their
mounting bracket
4.
Position the solenoid and tank so you can see the rear knock sensor. Disconnect the electrical connector from the sensor; then remove the sensor
with a 24 mm socket on a universal extension.
