TL L5-2451cc 2.5L SOHC G25A4 FI (1995)
Air Bag Control Module: Service and Repair
CAUTION:
^
During installation or replacement, do not bump (impact wrench, hammer etc.) the area near the SRS unit.
^
Do not damage the SRS unit terminals or connectors.
^
Do not disassemble the SRS unit; it has no serviceable parts.
^
Store the SRS unit in a clean, dry area.
^
Do not use any SRS unit which has been subjected to water damage or shows signs of being dropped or improperly handled, such as dents, cracks
or deformation.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
3. Disconnect the airbag connectors.
Driver's Side:
^
Remove the access panel from the steering wheel, then disconnect the 2P connector between the driver's airbag and cable reel.
Replacement - Front Passenger's Side
Front Passenger's Side:
^
Remove the glove box.
^
Disconnect the connector between the front passenger's airbag and SRS main harness. On a 95-96 model, connect the short connector to the
front passenger's airbag connector.
4. Remove the radio panel.
Replacement - Front Passenger's Side
5. Remove the center console and dashboard center trim.
6. Disconnect the SRS main harness 18P connector from the SRS unit.