TL L5-2451cc 2.5L SOHC MFI (1997)
2. Coat a new cam boot with recommended rubber grease in the caliper seal set, and install it in the caliper body
3. Apply recommended rubber grease in the caliper seal set to the pin contacting area of the cam, and install the cam and lever assembly into the
caliper body.
4. Install the return spring.
CAUTION:
-
When the cam and lever were separated, be sure to assemble them before installing the cam in the caliper body. Install the lever and spring
washer, apply locking agent to the threads, and tighten the parking nut while holding the lever with a vise.
-
Avoid damaging the cam boot since it must be installed before the cam.
-
When installing the cam, do not allow the cam boot lips to turn outside in
5. Install the pin in the cam.
6. Install a new O-ring on the sleeve piston.
7. Install the sleeve piston so the hole in the bottom of the piston is aligned with the pin in the cam, and two pins on the piston are aligned with the
holes in the caliper.
