TL L5-2451cc 2.5L SOHC MFI (1997)
Cruise Control Switch: Testing and Inspection
Set/Resume Switch Test
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing
repairs or service.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.
3. Disconnect the airbag connector(s).
Set/Resume Switch Test/Replacement
Driver's Side:
^ Remove the access panel from the steering wheel, then disconnect the 2P connector between the driver's airbag and cable reel.
Set/Resume Switch Test/Replacement
Front Passenger's Side ('95 - 96 models only):
^ Remove the glove box.
^ Disconnect the front passenger's 3P connector from the SRS main harness, and connect the short connector (RED) to the front passenger's
airbag 3P connector.
4. Remove the dashboard lower cover and knee bolster.