Blower Motor Removal and Installation
Blower Motor: Service and Repair
Blower Unit Removal and Installation
Blower unit replacement
1. Remove the evaporator. Refer to Evaporator Case - Service and Repair - Procedures See: Evaporator Case/Service and Repair
2. Remove the mounting nut from the blower unit.
NOTE:
When removing the mounting nut, take care not to damage or bend the fuel pipes, brake pipes, etc.
3. Disconnect the connector from the recirculation control motor, and remove the self-tapping screw from the pipe clamp.
4. Remove the mounting bolt, then remove the blower unit by moving it back and toward the right.