TL L5-2451cc 2.5L SOHC MFI (1997)
Fuel Pressure Release: Service and Repair
Models With Service Bolt
Before disconnecting fuel pipes or hoses, release pressure from the system by loosening the 6 mm service bolt on top of the fuel filter.
WARNING
-
Do not smoke while working on the fuel system. Keep open flames or sparks away from your work area.
-
Be sure to relieve fuel pressure while the ignition switch is off.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable from the battery negative terminal.
3. Remove the fuel fill cap.
4. Use a box end wrench on the 6 mm service bolt at the fuel filter while holding the special banjo bolt with another wrench.
5. Place a rag or shop towel over the 6 mm service bolt.
6. Slowly loosen the 6 mm service bolt one complete turn.
NOTE:
-
A fuel pressure gauge can be attached at the 6 mm service bolt hole.
-
Always replace the washer between the service bolt and the special banjo bolt whenever the service bolt is loosened.
-
Replace all washers whenever the bolts are removed.
