TL L5-2451cc 2.5L SOHC MFI (1997)
Coolant: Service and Repair
ENGINE COOLANT REFILLING AND BLEEDING
CAUTION: When pouring engine coolant, be sure to shut the relay box lid and not to let coolant spill on the electrical parts or the paint. If any
coolant spills, rinse it off immediately.
NOTE:
-
Perform this procedure when the engine is cool.
-
Before replacing the coolant, turn the ignition ON (II), slowly turn the climate control temperature knob to 90° and turn off the ignition. This will
allow the coolant in the heater to drain out with the rest of the system.
1. When the radiator is cool, remove the radiator cap. Loosen the drain plug, and drain the coolant.
2. Remove the drain bolt from the right side of the cylinder block to drain the block.
3. Apply liquid gasket to the drain bolt threads, then reinstall the bolt with a new washer and tighten it securely.
4. Tighten the radiator drain plug securely.
5. Remove, drain and reinstall the reservoir. Fill the tank halfway to the MAX mark with water, then up to the MAX mark with antifreeze.
6. Mix the recommended antifreeze with an equal amount of water in a clean container.
NOTE:
-
Use only genuine Honda antifreeze/coolant.
-
For best corrosion protection, the coolant concentration must be maintained year-round at 50% minimum. Coolant concentrations less than
50% may not provide sufficient protection against corrosion or freezing.
-
Coolant concentrations greater than 60% will impair cooling efficiency and are not recommended.
CAUTION:
-
Do not mix different brands of antifreeze/coolants.
-
Do not use additional rust inhibitors or anti-rust products; they may not be compatible with the coolant.
Engine Coolant Refill Capacity [including reservoir (0.7 l (0.7 US quart 0.6 Imp quart))]:
5.2 l (5.5 US quart 4.6 Imp quart)
7. Loosen the air bleed bolts in the thermostat housing and intake manifold, then fill the radiator to the bottom of the filler neck with the coolant
