TL L5-2451cc 2.5L SOHC MFI (1997)
3. Remove the wire harness cover and heat shields.
4. Remove the secondary HO2S.
5. Install the secondary HO2S in reverse order of removal.
-
Be sure to follow the instructions below when installing the secondary HO2S.
CAUTION: Do not let the secondary HO2S wire harness contact the heat shields. If the secondary HO2S wire harness contacts the heat shield,
keep the wire harness away from the heat shield by moving the wire harness clamp.
NOTE: Check that the clearance is more than 4 mm (0.2 inch) between the heat shields and rear side of the TWO as shown. If the clearance is
less than 4 mm (0.2 inch), loosen the 6 x 1.0 mm bolts on the heat shields and tighten them adjusting the clearance.
