TL L5-2451cc 2.5L SOHC MFI (1997)
Fuel Quick-Connect Fittings: Service and Repair
Disconnection
WARNING: Do not smoke while working on the fuel system. Keep open flames away from your work area.
1. Disconnect the battery negative cable.
2. Remove the fuel fill cap, and relieve fuel pressure in the tank.
3. Relieve fuel pressure.
4. Check the fuel quick-connect fittings for dirt, and clean if necessary.
5. Hold the connector with one hand and press down the retainer tabs with the other hand, then pull the connector off.
NOTE:
-
Be careful not to damage the pipe or other parts. Do not use tools.
-
If the connector does not move, keep the retainer tabs pressed down, and alternately pull and push the connector until it comes off easily.
-
Do not remove the retainer from the pipe; once removed, the retainer must be replaced with a new one.
7. To prevent damage and keep out foreign matter, cover the disconnected connector and pipe end with plastic bags.
NOTE:
-
The retainer cannot be reused once it has been removed from the pipe.
Replace the retainer when:
-
replacing the fuel pump.
-
replacing the fuel feed pipe.
-
it has been removed from the pipe.
-
it is damaged.
