TL L5-2451cc 2.5L SOHC MFI (1997)
Clockspring Assembly / Spiral Cable: Service Precautions
Steering Column Removal
Steering Column Removal
CAUTION:
^
Before removing the steering column, first disconnect the connector between the cable reel and the SRS main harness.
^
If the steering column is going to be removed with- out dismounting the steering wheel, lock the steering by turning the ignition key to 0-LOCK
position, or remove the key from the ignition so that the steering wheel will not turn.
NOTE:
^
When the airbag assembly and cable reel are disconnected, and the battery is reconnected and the ignition switch is turned ON (II), the SRS unit
will store this as an open in the driver's airbag inflator, and the SRS indicator light will come on. In such a case, make sure to confirm the DTC,
then clear the SRS unit memory.
^
For disconnecting the spring-loaded lock type connector.
Do not replace the original steering wheel with any other design since it will make it impossible to properly install the airbag (use only genuine Honda
replacement parts).
After reassembly, confirm that the wheels are still turned straight ahead and that the steering wheel spoke angle is correct. If minor spoke angle
adjustment is necessary, do so only by adjusting the tie-rods, not by removing and repositioning the steering wheel.
