TL V6-3.2L (2004)
11. Release the hooks (A, B, C), then remove the outer handle front seat (D) and outer handle rear seat (E).
12. Remove the outer handle base (A).
1. Loosen the nut.
2. Release the tab (B) and slide the outer handle base forward.
13. Disconnect the outer handle rod (A) from outer handle base (B).
14. Install the handle in the reverse order of removal, and note these items:
-
Reinstall the lock cylinder (driver's door) or the outer handle holder (passenger's door) before installing the outer handle cover.
-
Make sure the cylinder switch harness is routed properly (driver's door).
-
Make sure the cylinder switch connector is plugged in properly, and each rod is connected securely (driver's door).
-
Make sure the door key cylinder/door locks operate properly (driver's door).
-
Make sure the door handle works properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to prevent water
leaks.
