TL V6-3.2L (2004)
7. Disconnect the connector (A) from the regulator (B).
8. Remove the bolts (C) and loosen the bolts (D), then remove the regulator through the hole in the door.
9. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
10. Install the glass and regulator in the reverse order of removal, and note these items:
-
Special corrosion-resistant bolts are used in this area. The use of any other type of hardware may result in accelerated corrosion.
-
Roll the glass up and down to see if it moves freely without binding.
-
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
-
Adjust the position of the glass as necessary.
-
Check for water leaks.
-
Test-drive and check for wind noise and rattles.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to prevent water
leaks.
