acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

All Technical Service Bulletins for Rear Shelf:|04-043|Page 8528 > < All Technical Service Bulletins for Rear Shelf:|04-043|Page 8526
Page 7
background image

3. Peel the backing off the second piece of felt, and center it onto the bottom side of the retractor. Make sure the edge of the felt is against the back of

the retractor frame. Then wrap the ends of the felt around the top side of the retractor, and firmly press them into place. Make sure the felt is not
under the edge of the retractor mounting bolt.

4. Reinstall the retractor, and make sure the noise is gone before installing the remaining parts.

REPAIR PROCEDURE 8

2007 Models thru VIN 19U.....7A025482 only:

Replace the rear center seat belt retractor:

^ Refer to page 24-10 of the 2007-08 TL Service Manual, or

^ Online, enter keywords REAR BELT, and select Rear Seat Belt Replacement from the list.

REPAIR PROCEDURE 9

*2004-08 Models - All:*

1. Remove the two speakers and the subwoofer from the rear shelf:

^

Refer to the Body Electrical, or Audio, Navigation, and Telematics section of the appropriate service manual, or

^

Online, enter keywords REAR SPEAKERS, and select Speaker Test/Replacement from the list.

2. Cut six 75 mm x 205 mm pieces of insulation pad.

All Technical Service Bulletins for Rear Shelf:|04-043|Page 8528 > < All Technical Service Bulletins for Rear Shelf:|04-043|Page 8526