TL V6-3.2L (2004)
Trim Panel: Service and Repair
Trim Removal/Installation - Door Areas
Trim Removal/Installation - Door Areas
Special Tools Required
-
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
Front Door Sill Area
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend or scratch the trim and panels.
1. Left side: Remove the footrest.
2. Remove the left kick panel (A) or the right kick panel (B).
1. Pull out the front door opening trim (C) from the kick panel hooks (D) and the front door opening flange.
2. Left side: Pull the hood opener knob (E) and hold it.
3. Pull the kick panel back by hand to detach the clips (F, G), and to release the hook (H) and tab (I) from the front door sill trim (J), then remove
the panel.
3. Pull the front door sill trim (A) up by hand to detach the clips (B), and to release the hooks (C) and tabs (D) from the B-pillar lower trim (E), then
remove the trim.
4. If necessary, pull the front side outer trim (F) up to detach the clips (G), then remove the trim.