TL V6-3.2L (2004)
Trunk / Liftgate Lock: Service and Repair
Trunk Pass-Through Cover Key Cylinder
Trunk Pass-through Cover Key Cylinder Replacement
Special Tools Required
-
KTC trim tool set SOJATP2014 *
*
Available through the American Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to scratch the cover.
1. Using a trim tool, pry the rear seat handle (A) up at both hook portions (B) on the forward side of the trunk pass through cover (C). Then slide the
handle half-way up.
2. From the trunk compartment side of the cover, using a small screwdriver, press the inside hook (A) down through the access hole (B).
3. While pressing the hook, pry the trunk-side handle (C) up with a trim tool.
4. Remove the trunk-side handle (A) and rear seat handle (B) at the same time.
5. Remove the retainer clip (C), then remove the trunk pass-through cover key cylinder (D) from the cover (E).
6. Install the key cylinder in the reverse order of removal, and note these items:
-
Put the two handles together before installing them on the trunk pass-through cover.
