TL V6-3.2L (2004)
Power Seat Control Module: Testing and Inspection
Power Seat Control Unit Input Test
NOTE: Before troubleshooting the DPMS, troubleshoot the multiplex integrated control system first using B-CAN System Diagnosis Test Mode A.
1. Turn the ignition switch OFF.
2. Remove the driver's power seat.
NOTE: Be careful not to scratch the interior trim.
3. Disconnect the connectors from the power seat control unit (A).
NOTE: All connectors view are from wire side of female terminals.
4. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
-
If the terminals took OK, go to step 5.