TL V6-3.2L (2004)
3.
Place a mark on the masking tape that aligns with the seam of the weatherstrip.
4.
Push down on the top of the old weatherstrip with your thumb until a small section separates from the moonroof. Once a section has started to
separate, grip it and pull outward, working around the moonroof until the weatherstrip is completely removed (note the locations of the holes in the
weatherstrip).
5.
Align the seam of the new weatherstrip with the mark on the masking tape. Make sure the holes are pointed in the same direction as noted in step
4.
6.
Press the ridge of the new weatherstrip into the groove on the moonroof where the masking tape is marked. Work toward one corner, then go back
to the middle and work toward the opposite corner. Be careful not to stretch the weatherstrip.
7.
Continue pressing along one side, from corner to corner; then press along the opposite side, from corner to corner.
8.
At the rear of the moonroof, continue pressing from one corner to the middle; then press from the opposite corner to the middle until the strip is
completely installed.
9.
Reinstall the moonroof glass (refer to the Glass Replacement procedure).
10.
Check for proper fit of the new weatherstrip by opening and closing the moonroof.
Disclaimer
