TL V6-3.2L (2004)
Coolant: Service and Repair
Coolant Replacement
1. Start the engine. Set the heater temperature control dial to maximum heat, then turn off the ignition switch. Make sure the engine and radiator are
cool to the touch.
2. Remove the radiator cap.
3. Loosen the drain plug (A), and drain the coolant.
4. Install a rubber hose (A) on the drain bolt (B) located at the rear of the cylinder block, then loosen the drain bolt.
5. When the coolant stops draining, tighten the drain bolt.
6. Tighten the radiator drain plug securely.
7. Remove, drain, and reinstall the reserve tank.
8. Fill the reserve tank to MAX mark (A) with Honda All Season Antifreeze/Coolant Type 2 (P/N OL999-9001).
9. Pour Honda All Season Antifreeze/Coolant Type 2 into the radiator up to the base of the filler neck.
NOTE:
^
Always use Honda All Season Antifreeze/Coolant Type 2 (P/N OL999-9001). Using a non-Honda coolant can result in corrosion, causing the
cooling system to malfunction or fail.