TL V6-3.2L (2004)
6. If four numbers or marks (1 to 4 or V to VVVV) are printed around the outside of the filter, you can use the following procedure to tighten the
filter.
^
Spin the filter on until its seal lightly seats against the block, and note which number or mark is at the bottom.
^
Tighten the filter by turning it clockwise three numbers or marks from the one you noted. For example, if mark V is at the bottom when the
seal is lightly seated, tighten the filter until the mark VVVV comes around to the bottom.
7. After installation, fill the engine with oil up to the specified level, run the engine for more than 3 minutes, then check for oil leakage.
8. Reset the multi-information display.
