TL V6-3.2L (2004)
Front Crankshaft Seal: Service and Repair
Pulley End Crankshaft Oil Seal Installation - In Car
Special Tools Required
^
Oil seal driver, 64 mm 070AD-RCA0100
1. Remove the crankshaft position (CKP) sensor, timing belt, and timing belt drive pulley.
2. Remove the pulley end crankshaft oil seal.
3. Clean and dry the crankshaft oil seal housing.
4. Apply a light coat of multipurpose grease to the crankshaft and to the lip of the seal.
5. Using the seal driver, drive in the crankshaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any excess
grease off the crankshaft, and check that the oil seal lip is not distorted.
6. Install the timing belt drive pulley, CKP sensor, and timing belt.
