TL V6-3.2L (2004)
16. Check the camshaft pulley marks.
^
If the camshaft pulley marks are at TDC, go to step 17.
^
If the camshaft pulley marks are not at TDC, remove the timing belt and repeat steps 2 through 16.
17. Install the drive belt.
18. Install the side engine mount bracket (A), then tighten the bolts in the numbered sequence shown.
19. Install the ground cable (B).
20. Install the right front tire/wheel.
NOTE: On M/T models be careful not to damage or chip the paint of the brake calipers when installing the wheels.
21. Perform the crankshaft position (CKP) pattern clear/CKP pattern learn procedure.
