TL V6-3.2L (2004)
Compressor Clutch: Service and Repair
Compressor Clutch Overhaul
Special Tools Required
A/C clutch holder, Robinair 10204 or Kent-Moore J37872, or Honda Tool and Equipment KMT-J33939, commercially available
Compressor Clutch Overhaul
1. Remove the center bolt (A) while holding the pressure plate with a commercially available A/C clutch holder (B).
2. Remove the pressure plate (A) and shim(s) (B), taking care not to lose the shim(s). If the clutch needs adjustment, increase or decrease the number
and thickness of shims as necessary, then reinstall the pressure plate, and recheck its clearance.
NOTE: The shims are available in three thicknesses: 0.1 mm, 0.3 mm and 0.5mm.
3. If you are replacing the field coil, remove the snap ring (A) with snap ring pliers, then remove the pulley (B). Be careful not to damage the pulley
or the compressor.