TL V6-3.2L (2004)
NO - Go to step 63.
63. Measure voltage between ECM/PCM connector terminal D6 and body ground.
Is there about 5 V?
YES - Go to step 71.
NO - Go to step 64.
64. Turn the ignition switch OFF.
65. Disconnect the connector from each of these sensors, one at a time, and measure voltage between ECM/PCM connector terminal D6 and body
ground with the ignition switch ON (II).
-
MAP sensor
-
Output shaft (countershaft) speed sensor
Is there about 5 V?
YES - Replace the sensor that restored 5 V when disconnected.
NO - Go to step 66.
66. Turn the ignition switch OFF.
67. Jump the SCS line with the HDS.
68. Disconnect the connectors from these sensors.
-
MAP sensor
-
Output shaft (countershaft) speed sensor
69. Disconnect ECM/PCM connector D (17P).