TL V6-3.2L (2004)
6. Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
7. Press a new wheel bearing (A) into the knuckle (B) using the old bearing (C), a steel plate (D), the special tools, and a press.
NOTE:
^
Install the wheel bearing with the wheel sensor magnetic encoder (E) (brown color), toward the inside of the knuckle.
^
Remove any oil, grease, dust, metal debris, and other foreign material from the encoder surface.
^
Keep all magnetic tools away from the encoder surface.
^
Be careful not to damage the encoder surface when you insert the wheel bearing.
8. Install the new front knuckle ring (A) on the inside of the knuckle by aligning the cutout portion (B) on the ring with the wheel sensor hole (C) in
the knuckle. Be careful not to damage or deform the ring when installing it,
9. Install the snap ring (A) securely in the knuckle (B).
10. Install the splash guard (C), and tighten the screws (D) to the specified torque value.
