TL V6-3.2L (2004)
52. Check for continuity between PGM-FI main relay 1 (FI MAIN) 4P connector terminal No.4 and ECM/PCM connector terminal A5.
Is there continuity?
YES - Test PGM-FI main relay 1 (FI MAIN). If the relay is OK, update the ECM/PCM if it does not have the latest software, or substitute a
known-good ECM/PCM, then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.
NO - Repair open in the wire between PGM-FI main relay 1 (FI MAIN) and the ECM/PCM (A5).
53. Reconnect ECM/PCM connector E (31P).
54. Turn the ignition switch ON (II).
55. Measure voltage between body ground and ECM/PCM connector terminals E4.
Is there battery voltage?
YES - Go to step 62.
NO - Go to step 56.
56. Turn the ignition switch OFF.
57. Remove the kick panel. Then remove PGM-FI main relay 1 (FI MAIN) (A) from the under-hood fuse/relay box.
58. Turn the ignition switch ON (II).
