TL V6-3.2L (2004)
2. Turn the ignition switch ON (II).
3. Select READ DATA in the REPLACE ECM/PCM with the HDS.
4. Turn the ignition switch OFF.
5. Jump the SCS line with the HDS.
6. Pull back the carpet.
7. Remove the ducts (A).
8. Disconnect the ECM/PCM connectors (B).
9. Remove the bolts (C), then remove the ECM/PCM (D).
10. Install the ECM in the reverse order of removal.
11. Open the SCS with the HDS.
12. Turn the ignition switch ON (II).
NOTE: If DTC: P0630 "VIN Not Programmed or Mismatch" is stored at this time, ignore it and continue this procedure.
13. Input the VIN to the ECM/PCM with the HDS.
14. Select WRITE DATA in the REPLACE ECM/PCM with the HDS.
15. Rewrite the immobilizer code with the ECM/PCM replacement procedure in the HDS; it allows you to start the engine.
16. Reset the ECM/PCM with the HDS.
17. Do the Idle learn procedure
18. Do the CKP pattern learn procedure.
