TL V6-3.2L (2004)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
Updating With the GNA600
UPDATING WITH THE GNA600
NOTE:
^ For more information on the GNA6OO, refer to the GNA600 User's Guide. This guide is on ISIS, under the Tool Information heading.
^ To update an AcuraLink control unit, refer to Service Bulletin 07-027, Updating the AcuraLink Control Unit
Two modes of updating can be used with the GNA600:
Pass-Thru mode and Storage mode. Use Pass-Thru mode when the GNA600 can be connected to an iN workstation and the vehicle at the same time. Use
Storage mode when the GNA600 cannot be connected to the iN workstation and the vehicle at the same time.
GNA600 Updating in Pass-Thru Mode
1. If not already done, load the latest HDS PC software onto your iN workstation. For loading instructions, refer to the Tool Information publication
Installation Instructions for HDS PC Software on ISIS.
NOTE:
If the latest software is not loaded and you do a control unit/module update, the software may indicate the vehicle has the latest update when it
doesn't. Updates not done with the latest software are not covered under warranty.
2. From the iN workstation desktop, select CM Update (ECU Rewrite).
3. Connect the USB PC interface cable to the iN workstation and to the GNA600. Click on the Tools button on the right side of the screen, and make
sure the interface device is set to GNA600.
4. Return to the Updating Honda Control Modules main screen, and click on Pass-thru-Mode.
5. Connect the DLC cable to the GNA6OO and to the vehicle's DLC.
6. Turn the ignition switch to ON (I I), and wait until the green No.2 LED on the GNA6OO stays on. Click on the check mark to continue.
