TL V6-3.2L (2004)
^
If the value is Completed, go to step 6.
^
If the value is Not Completed, be sure the engine is at normal operating temperature (the ECT SENSOR (1) value is 176 or higher), and repeat
step 4.
6.
Do the high-rpm CKP pattern learn:
NOTE:
The low-rpm CKP pattern learn must be completed before you do the high-rpm CKP pattern learn.
^
Test-drive the vehicle on a level road: With the A/T in low gear, or the M/T in first gear, decelerate (with the throttle fully closed) from an
engine speed of 5,000 rpm down to 3,000 rpm.
^
Stop the vehicle, and put the transmission into Park or Neutral. Set the parking brake. Do not turn off the ignition.
7.
Connect the HDS to the DLC (if not already connected), and do this:
^
On the Selection Menu, select PGM-FI.
^
On the Mode Menu, select Data List.
8.
Check the value of PULSER F/B LEARN (HIGH RPM):
^
If the value is Completed, you are finished. Disconnect the HDS.
^
If the value is Not Completed, be sure the engine is at normal operating temperature (the ECT SENSOR (1) value is 176 or higher), and repeat
steps 4 thru 7.*
Disclaimer
