TL V6-3.2L (2004)
22.
Within 30 seconds of the LEDs on the GNA600 flashing green and yellow, reconnect the yellow No.3 connector of the AcuraLink reprogramming
cable to the yellow connector of the reprogramming cable adapter.
NOTE:
The time to update the software in the AcuraLink control unit varies, depending on the size of the main and sub-update programs.
23.
After the yellow LEDs on the GNA6OO stay on and the reprogramming is complete, disconnect the DLC cable from the GNA600. The AcuraLink
control unit has been updated.
*24. Disconnect both cable adapter connectors from the vehicle, then wait at least 20 seconds before reconnecting the AcuraLink 5P connectors.*
25.
Reattach the 5P connector to its mounting location to prevent rattles.
26.
Disconnect the reprogramming cable adapter from the reprogramming cable, and disconnect the reprogramming cable from the DLC cable before
storing the GNA600 kit components.
Verifying the AcuraLink system operation
27.
Do the AcuraLink self-diagnosis:
^
Turn the ignition switch to ON (II), and accept the navigation system disclaimer.
^
On the navigation buttons, press MAP/GUIDE, MENU, and CANCEL simultaneously until the "Select Diagnosis Items" screen comes on.
^
On the navigation screen, select XM (HIP).
^
Select XM (HIP) System Link.
*
^
Make sure the self-diagnosis is OK (all blocks are green). If a problem is indicated, refer to the appropriate service manual.*
28.
Enter the XM audio presets.
UPDATING THE ACURALINK CONTROL UNIT:
MODELS OTHER THAN 2007-08 TL AND 2007-09
MDX
1.
Write down the XM audio presets.
