TL V6-3.2L (2004)
2. Place the driver's airbag (B) in the steering wheel, and secure it with new Torx bolts (C).
3. Connect the cable reel 4P connector (A) to the driver's airbag 4P connector, then install the access panel (B) on the steering wheel.
4. Connect the battery negative cable.
5. Connect the HDS and clear the DTCs.
6. After installing the airbag, confirm proper system operation:
-
Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
-
Make sure the horn works.
