TL V6-3.2L (2004)
Air Bag Control Module: Service and Repair
Initializing the OPDS (Occupant Position Detection System) Unit
Initializing the OPDS (Occupant Position Detection System) Unit
When a seat-back cover, seat-back cushion, and~or OPDS unit is replaced, initialize the OPDS by following the procedure.
NOTE: A new (uninitialized) OPDS unit installed with a faulty OPDS sensor can cause DTC 85-71.
1. Erase the DTC memory (see "Erasing the DTC Memory").
2. Make sure the front passenger's seat is dry. Set the seat-back in a normal position, and make sure there is nothing on the seat.
3. Make sure the ignition switch is OFF and the MES connector is not shorted.
4. Make sure the driver's seat belt buckle is not buckled.
5. Connect the HDS to the DLC (A).
6. Turn the ignition switch ON (II).
7. From the HDS Main Menu, select SRS, then Misc Test, then adjustments. Select OPDS INIT. in the Adjustment Menu. Follow the screen prompts
to initialize the OPDS.
8. Turn the ignition switch OFF.
9. Disconnect the HDS from the DLC.
NOTE: If the OPDS system fails to initialize several times, replace the OPDS sensor and retry. If the OPDS system continues to fail to initialize,
replace the OPDS unit.
