TL V6-3.2L (2004)
Seat Belt Retractor: Testing and Inspection
Inspection
Out of Vehicle
For front seat belt retractor with seat belt tensioner, review the SRS component locations and the precautions and procedures before performing repairs
or service.
Retractor
1. Before installing the retractor, check that the seat belt can be pulled out freely.
2. Make sure that the seat belt does not lock when the retractor (A) is leaned slowly up to l5 from the mounted position. The seat belt should lock
when the retractor is leaned over 4O Do not attempt to disassemble the retractor.
3. Replace the seat belt with a new assembly if there is any abnormality. Do not disassemble any part of the seat belt for any reason.
In-vehicle
1. Check that the seat belt is not twisted or caught on anything.
2. After installing the anchors, check for free movement on the anchor bolts. If necessary, remove the anchor bolts and check that the washers and
other parts are not damaged or improperly installed.
3. Check the seat belts for damage or discoloration. If necessary, clean the seat belts with soap and water only, then wipe them off with a clean towel.
