TL V6-3.2L (2004)
Transmission Position Switch/Sensor: Service and Repair
Transmission Range Switch Replacement
Transmission Range Switch Replacement
1. Raise the vehicle and make sure it is securely supported.
2. Shift to the N position.
3. Remove the transmission range switch cover.
4. Disconnect the transmission range switch connector.
5. Remove the transmission range switch.
6. Make sure the selector control shaft is in the N position. If necessary move the shift lever to the N position.
NOTE: Do not use the selector control shaft to adjust the shift position. If the selector control shaft tips are squeezed together it will cause a
faulty signal or position due to play between the selector control shaft and the switch. The clearance (A) between selector contract shaft tips is 2.0
mm (0.08 inch).
