TL V6-3.2L (2004)
23. Assemble pump rotor (A) to the pump cover (B) with its "^" mark (C) facing up.
24. Set the 10 vanes (D) in the grooves in the rotor. Make sure that the round ends (E) of the vanes are in contact with the sliding surface of the cam
ring.
25. Coat the new 15.2 mm O-ring (A) with power steering fluid, and install it into the groove in the side plate (B).
26. Install the side plate on the cam ring (C) by aligning the roll pin set holes (D) in the side plate with the roll pins (E).
27. Coat the new 51 mm O-ring (A) with power steering fluid, and position it in the bottom of the pump housing.
28. Install the pump cover assembly (B) in the pump housing. Tighten the bolts to the specified torque.
29. Coat the flow control valve (A) with power steering fluid, then install it and the spring (B) in the pump housing.
